How is Epoxy Flooring Palatine Implemented?

How is Epoxy Flooring Palatine Implemented?

Epoxy flooring is the most suitable kind of flooring for a garage; it is durable, strong and can withstand tough conditions. If you ever wondered what are the steps that epoxy floor coating Palatine firms implement in order to successfully install the epoxy flooring, then you have come to the right place.

The first step is preparing the floor. They have to know if there is a coating on the floor as epoxy coating will react with any installed coating, this is why it is important to know the kind of current coating before implementing epoxy coating. It is also important to check for any grease or oil stains that might exist. If any stains are found, they have to be cleaned before the application of epoxy flooring can begin.  Any rubber residue will also have to be sanded before the implementation of the epoxy flooring. Lastly, random areas will be tested for any undetected coatings or sealers.

The second step is to etch the floor with a masonry cleaner or muriatic acid. This is done in 3 steps; the first one is to presoak the floor with a garden hose. The second step is to mix acid with water to make a solution of 4:1 (water: acid).  After the solution is poured evenly, the entire floor is rinsed with water.

The third step is leaving the floor to completely dry. This is because any residual moisture that is trapped under the epoxy coating will weaken the bond between the concrete surface and the epoxy floor coating Naperville. The floor should be left between 7 and 10 days so it can dry. It depends on the temperature and the humidity of the place.

The fourth step is to determine the amount of the material needed for the project. It is important to know that epoxy coatings don’t cover the same surface areas like paints and other coating materials. This is why it is essential to check for the coverage rate of the chosen product before deciding on the amount to purchase.

The fifth step is to start installing the floor coating. First, the pigment is mixed, then the hardener or the catalyst is added and the compound is mixed again. It is recommended to use a paint-mixing paddle of a power drill to guarantee best results. It is also recommended not to mix it at high speed to avoid the creation of bubbles. The compound is then applied to the floor with a ¾-inch nap roller. The back corner is where the coating should start so you work towards the exit so you do not get stuck at the corner when you are done. Try to be quick because most epoxy coatings have a short working period.

The sixth step is to leave the epoxy coating to completely cure, the amount needed will vary between one coating and another. Lastly, check the recoating times because re coating it late is just as bad as recoating it early.

Testimonials